Coffee Adjustable Silicone Swimming Goggles / Kids Swim Goggles
2. adjustable strap,waterproof
3. latex free,durable,high quality
4. super wear resistant,uv resistant
Coffee Adjustable Silicon Gel Swim Goggles UV Resistant
1. The headstrap&cushion is made of silicone rubber which has
high water resistance and temperature resistance which ensures
2. The lens made of PC,UV material,it protects the eyes from
harmful ultraviolet rays for outdoor use.
3. The inner side of the eyecup processed with special coating for
anti-fog,which enhance the clear of view.
4. The middle of the headstrap was double and prevented slide
free size for adults
Lens:crystal clear vision;Shatter resistant lenses make of quality
Eyecup:soft and vomfortable silicone gasket;
Head strap:100%silicone head strap;easy adjustable strap for
Uni-body design,automatic adjustment button,easy to use
144pcs/CTN , CTN size:49.5*38*37.5CM , or at your requirement
Usually 10 days after receiving th the 30% deposit,or based on
1. Please adjust the length of the headstrap and nosestrap to give
a comfortable fit to face in case the water leakage.
2. With googles in position on face,stretch the headstrap over the
back of the head.Headstrap should rest on the crown of the head at
about a 45 degree angle to prevent leakage.
3. Put the inside of lenses fully covered by water before use,so
that the anti-fog treatment effective best.
4. Do not rub the surface of lenses with a towel or nail to avoid
the scratch and decrease of anti-fog effect and clearance.
1. Children use the goggle must guided by adult.
2. Do not swim underwater below 2 meters.
3. Do not used as sun goggle and in the sun direct,it will be hurt
How to keep
After use,wash the goggle with water,store it in the box after
cutting water out,it can prolong the anti-fog period.
1. Do not washed after buying goggles goggles fogging oil inside
the lens, so the effect will be greatly reduced fog material within
the lens is to use a good impact polycarbonate material and surface
of theanti-fog treatment;
2. The anti-fog as hydrophilic ,swamping the goggle before using
deprives fogging problem.
3. Please avoiding finger or fingernail touch the glasses ,
antifogging surface would be scratched or damaged .
4. Please water washing every single use ,dirt coating decreases
the anti-fog effect .or use gentle detergent as well .(caution:use
aboundant foam to clean the wet goggle ,avoiding fingernail scratch
1. Mold / Tooling: According to customer’s 2D/3D drawing, or
sample, or detailed dimensions , our engineer completes the designs
for the mold. The Mold Tooling Department makes the mold according
to the drawing. Mold 's life time: can be used for 200,000 times or
2. Material preparation: Purchase and mix the materialsas per
customer’s requirements (hardness, color, brand, etc.)
3. Mold trial: The mold trial runs after the completion of the
mold. Several free samples from mold trial can be offered
tocustomer for test. Once the samples are approved by the customer,
mass production can be started. If the samples are not qualified,
the mold will be modified until receipt of the confirmation from
4. Mass production: Install the mold onto the Hydraulic press
machine. Put the processed material in the mold for vulcanization.
The product comes into certain shapes as required.